conga-SEVAL

Evaluation Carrier Board for SMARC 2.0 modules

Active Filters:

    Add Filter:

    There are 1,000's of possible configurations of our products, and therefore every possible configuration may not be shown with this tool.
    If you don't find the configuration you require contact your congatec Sales representative for further assistance.

    Specification


    To achieve a quick start with SMARC congatec offers an evaluation carrier board, which routes all the SMARC signals to standard interface connectors.
     

      I/O

      • 1x PCIe x4 | 1x miniPCIe | 1x PCIe x1 | 1x M.2 socket Key E
      • 1x SATA
      • 1x USB 3.0 | 1x USB 2.0 | 1x micro USB 2.0 (OTG) | 1x USB Type C with PD and DP1 via Alternate Mode
      • 2x RS-232 (1x internal RX/TX on pinheader, 1x RX/TX w/ handshake on DSUB9)
      • 2x CAN
      • GPIO
      • 1x SDIO interface
      • 2x I²C Bus
      • 1x eSPI/SPI1 on header
      • 1x SPI Bus
      • 1x FAN control
      • 1x Disk Drive Power Output
         

      Ethernet

      •  2x Gigabit Ethernet
         

      Internal Graphic Interface

      •    2x24 bit LVDS connector shared with 2x eDP or 2xDSI

       

      External Graphic Interfaces

      • 1x DP++
      • 1x HDMI

       

      Audio

      •    I2S Audio interface and HDA interface

       

      Documents

      Part Number

      007010
      conga-SEVAL

      Evaluation Carrier Board for SMARC 2.0 modules.

      077650
      conga-SKIT/APL

      Starterkit for SMARC 2.0 modules

      Technology

      Technology Leader congatec has been driving industry standards since 2005

      Support

      Engineering and support for standard and customized products in all major regions

      Customizing

      congatec Technical Services for customized design

      Contact

      Embedded in your success.
      Get in touch!